Changing The Input Display - Onkyo HT-R960 Instruction Manual

First Time Setup—Continued
2
Use the Up and Down [
buttons to select "1. Input
Assign," and then press
[ENTER].
3
Use the Up and Down [
buttons to select "3. Digital
Audio Input," and then press
[ENTER].
4
Use the Up and Down [
buttons to select an input selec-
tor, and then use the Left and
Right [
COAX1: Select if the component is
COAX2: Select if the component is
OPT1: Select if the component is
OPT2: Select if the component is
- - - - -: Select if the component is
5 Press the [SETUP] button.
Setup closes.
Notes:
• When an HDMI IN is assigned to an input selector in
"HDMI Input Setup" on page 46, this input assign-
ment is automatically set to the same HDMI IN. And
in addition to the usual inputs (e.g., COAX1, COAX2,
etc.), you can also select HDMI inputs. If you change
the input assignment from an HDMI IN to one of the
other inputs (e.g., COAX1 or COAX2), be sure to set
48
]/[ ]
]/[ ]
]/[ ]
]/[ ] buttons to select:
connected to DIGITAL IN
COAXIAL 1.
connected to DIGITAL IN
COAXIAL 2.
connected to DIGITAL IN
OPTICAL 1.
connected to DIGITAL IN
OPTICAL 2.
connected to an analog
input.
the"Automatic Audio Input Selection Setup" on
page 49 to the same input (e.g., COAX1 (Auto) or
COAX2 (Auto)).
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.

Changing the Input Display

If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE IN/OUT
jacks, or connect an RI Dock to the CBL/SAT IN jacks,
for to work properly, you must change this setting.
This setting can only be changed on the AV receiver.
1, 2
ON/STANDBY
STANDBY
THX MULTI CH DVD VCR/DVR CBL/SAT AUX
PHONES
A SPEAKERS B TONE MOVIE/TV MUSIC
LISTENING MODE
iPod with video: If you're using an iPod that supports
video output with the DS-A1 RI Dock, connect the
DS-A1 to the CBL/SAT IN jacks.
1
Press the [TAPE] or [CBL/SAT]
input selector button so that
"TAPE" or "CBL/SAT" appears on
the display.
TAPE
or
CBL/SAT
2 Press and hold down the [TAPE]
or [CBL/SAT] input selector but-
ton (about 3 seconds) to change
the setting.
TAPE
Repeat this step to select MD, CDR, or
or
DOCK.
For the TAPE input selector, the setting
changes in this order:
CBL/SAT
→
TAPE
DOCK
For the CBL/SAT input selector, the
setting changes in this order:
CBL/SAT
Note:
• DOCK can be selected for the TAPE input selector or
CBL/SAT input selector, but not both at the same time.
1, 2
MASTER VOLUME
TUNING PRESET
ENTER
TAPE TUNER CD SETUP RETURN
AUX INPUT
SETUP MIC VIDEO L AUDIO R
GAME DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
CLEAR
HT-R960
AV RECEIVER
→
MD CDR
→
↔
DOCK