Advanced Setup; Speaker Settings - Onkyo HT S3200 Instruction Manual

Advanced Setup

Common Procedures in Setup Menu
ENTER
SETUP
Number
Buttons

Speaker Settings

This section explains how to check the speaker settings and how to set them manually.
3. Sp Config (Speaker Configuration)
This section explains how to specify which speakers are connected and their sizes.
For speakers with a cone diameter larger than 6-1/2 inches (16 cm), specify Large (full
band). For those with a smaller diameter, specify Small (default crossover 120Hz).
The crossover frequency can be changed on page 53.
Note:
Speaker Configuration, Crossover Frequency, and Double Bass settings only need to be
changed if you're not using the speakers in this package. These settings cannot be changed
while headphones are connected, or speaker set B is on.
Subwoofer
*1
Front
*2
Center
*2
Surround
*1 If the "Subwoofer" setting is set to "No", this setting is fixed at "Large" and does not appear.
*2 If the "Front" setting is set to "Small", the "Large" option cannot be selected.
52
Remote
indicator
RECEIVER
Yes: Select if a subwoofer is connected (default).
No: Select if no subwoofer is connected.
Small: Select if the front speakers are small (default).
Large: Select if the front speakers are large.
Small: Select if the center speaker is small (default).
Large: Select if the center speaker is large.
None: Select if no center speaker is connected.
Small: Select if the surround speakers are small (default).
Large: Select if the surround speakers are large.
None: Select if no surround speakers are connected.
1 Press the [RECEIVER] button followed by
the [SETUP] button.
2 Use the Up and Down [ ]/[ ] buttons to
select the function, and then press the
[ENTER] button.
3
Use the Up and Down [ ]/[ ] button to
select item, and then use the Left and
Right [ ]/[ ] buttons to set them.
4 When you've finished, press the [SETUP]
button.
Setup closes.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Cone diameter