Basic Operations—Continued
This section explains functions that can be used with any
input source.
Press
[RECEIVER]
first
TONE, +, –
DIMMER
MUSIC OPTIMIZER
–, +, TONE
PHONES
DIMMER
Setting the Display Brightness
You can adjust the brightness of the display.
Press the [RECEIVER] button,
Remote
controller
and then press the remote
controller's [DIMMER] button
repeatedly to select: dim,
dimmer, or normal brightness.
You can also use the AV receiver's
[DIMMER] button.
AV receiver
Muting the AV receiver
You can temporarily mute the output of the AV receiver.
DISPLAY
MUTING
To unmute the AV receiver, press the remote
controller's [MUTING] button again, or adjust the
volume. The output is unmuted and the MUTING
indicator goes off.
Muting is cancelled when the AV receiver is set to
Standby.
SLEEP
Using the Sleep Timer
With the sleep timer, you can set the AV receiver so that
it turns off automatically after a specified period.
DISPLAY
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP]
button. Note that if you press the [SLEEP] button while
the sleep time is being displayed, you'll shorten the sleep
time by 10 minutes.
Press the [RECEIVER] button,
and then press the remote
controller's [MUTING] button.
The output is muted and the MUTING
indicator flashes on the display.
Press the [RECEIVER] button,
and then press the remote
controller's [SLEEP] button
repeatedly to select the required
sleep time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about 5
seconds, then the previous display
reappears.
SLEEP indicator
39