Remote Controller Setup; Lock Setup - Onkyo TX-NR5010 Instruction Manual

■
DNS Server
Enter the DNS server address provided by your ISP.
■
Proxy URL
To use a Web proxy, enter its URL here.
■
Proxy Port
If you're using a Web proxy, enter a proxy port number
here.
■
Network Standby
On
Off
This setting enables or disables control over the network.
When enabled, the NET indicator will be dimly-lit while
the AV receiver is in standby mode. Note that the indicator
may not light under certain conditions (
Note
• When set to "On", the power consumption slightly increases in
standby mode.
■
Update Notice
Enable
Disable
When this setting is enabled, you will be notified if a
firmware update via network is available.
Note
• Selecting "Never Remind me" on the notification window will
switch this setting to "Disable" (➔ page
• For details on the update notification, see "If the "Firmware
Update Available" window appears." (➔ page
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
(➔ page 27).
See "Initial Setup"

Remote Controller Setup

1 2
Main Menu
Remote ID
■
Remote ID
1, 2, or 3
When several Onkyo components are used in the same
room, their remote ID codes may overlap. To differentiate
the AV receiver from other components, you can change
its remote ID from "1", to "2" or "3".
➔ page 62
).
Note
• If you do change the AV receiver's remote ID, be sure to change
the remote controller to the same ID (see below), otherwise, you
won't be able to control it with the remote controller.
Changing the remote controller's ID
1 While holding down RECEIVER, press and hold
down Q SETUP until the RECEIVER lights (about
3 seconds).
2 Use the number buttons to enter ID 1, 2, or 3.
RECEIVER flashes twice.
26).
Remote Mode Setup
26).
See "Looking up for Remote Control Codes"
(➔ page 94).
3 4 5
"Setup"
Remote Controller Setup
En-86
Advanced Operations

Lock Setup

1 2 3 4
"Setup"
Main Menu Lock Setup
With this preference, you can protect your settings by
locking the setup menus.
■
Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will be
locked and you cannot change any setting.
5