Advanced Setup; Advanced Speaker Settings - Onkyo TX-SR304 Instruction Manual

Advanced Setup

Advanced Speaker Settings

The advanced speaker settings cannot be
changed while headphones are connected,
Speaker set B is on, or the multichannel input
is being used.
Crossover Frequency
This setting only applies to the speakers that you speci-
fied as Small in the "Speaker Configuration" on page 34.
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your speakers.
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
RECEIVER
[SETUP] button.
SETUP
2
Use the Up and Down [
buttons to select "1. SP Config,"
and then press [ENTER].
ENTER
3
Use the Down [
select "Crossover," and then use
the Left and Right [
tons to select a crossover fre-
quency.
Use the diameter of the smallest
speaker in your system when choosing
the crossover frequency.
Notes:
• For a more accurate setting, look up the frequency
• Choose a higher crossover frequency if you want more
]/[ ]
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can be set only
if the Subwoofer setting (step 3) is set to Yes, and the
Front setting (step 4) is set to Large in the Speaker Con-
figuration on page 34.
4
] button to
]/[ ] but-
5
Speaker cone
diameter
Over 8 in.
(20 cm)
6-1/2 to 8 in.
(16–20 cm)
5-1/4 to 6-1/2 in.
(13–16 cm)
3-1/2 to 5-1/4 in.
(9–13 cm)
Under 3-1/2 in.
(9 cm)
*Choose the setting suitable for the speaker.
Continue with step 4 of the "Double
Bass" setting below.
response in the manuals supplied with your speakers
and set accordingly.
sound from your subwoofer.
Use the Down [
select "Double Bass," and then
use the Left and Right [
buttons to select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off: Double Bass function off.
Press the [SETUP] button.
Setup closes.
When you want to go back up one
menu level to "SP Config," press the
SETUP
[RETURN] button.
Crossover
frequency
40/50/60Hz
80Hz
100Hz (default)
120Hz
150/200Hz*
] button to
]/[ ]
51