Checking The Lift-Off Switch; Replacing The Blades - Toro iMow 30050 Operator's Manual

5. Press and hold the rear bumper area and check for a
star in the display as shown in the following display:
Lt:– Rt:– Rr:*
6. Repeat step 5 for the left and right bumper areas.
Important
If the bumper does not respond (the star
does not appear), call 1-877-636-iMow (1-877-636-4669)
for service.
7. Press the Cancel button to return to the menu display.
Note: If the sound is activated, you will hear an electronic
sound when you press the bumper.

Checking the Lift-off Switch

The lift-off switch stops the blades if you raise the front
end of the lawn mower during operation. Check the
lift-off switch after every 50 operating hours.
1. Take the controller out of the drawer.
The following screen displays:
Manual
Settings
2. Press the Go button.
The following screen displays:
Sound
set
3. Use the scroll arrows until you see the following
display:
Diagnostics
4. Press the Go button.
The following screen displays:
Front Wheel Snsr
5. Press the Go button.
The following screen displays:
6. Lift the front end of the lawn mower a few inches
Note: After two or three seconds an audio message says,
"Please remove battery pack before lifting."
Important
above, call 1-877-636-iMow (1-877-636-4669) for
service.

Replacing the Blades

Always mow with sharp blades. Sharp blades cut cleanly
without tearing or shredding the grass.
The blade is sharp; contacting the blade can result
in serious personal injury.
Use extreme care when replacing or cleaning the
blades.
off
1. Stop the lawn mower and wait for all moving parts to
2. Remove the battery pack (Fig. 16).
3. Tip the lawn mower over.
4. Squeeze the black plastic tabs at the base of the blade
23
Front Wheel:
On the ground
(centimeters).
The following screen displays:
Front Wheel:
Lifted
If the display is different from that shown
Warning
stop.
and pull the blade toward you (Figs. 27 and 28).