Table of Contents
Advertisement
Figure 27
1. Blade base
1
Figure 28
1. Blade (3)
5. Hold the new blade by its base and push it onto the
spindle until you hear and feel a positive click.
Replacing the Batteries in the
Perimeter Switch
1. Open the perimeter switch case by squeezing the front
part of the tabs to the case (Fig. 6).
Figure 29
1. Perimeter switch case
2. Tab (2)
2
1
2. Blade
2
m-4995
2. Spindle
1
2
3
3.
1.5V C-cell battery (3)
24
2. Remove the old batteries from the battery
compartment.
3. Insert three 1.5V C-cell batteries (Fig. 6).
4. Close the perimeter switch case.
Storage
Store the lawn mower in a cool, clean, and dry place such
as an unheated garage. Cover the lawn mower to keep it
clean and protected. Do not store the lawn mower on its
bumpers or with anything pressing on the bumpers.
1. Clean the lawn mower housing. Refer to Cleaning the
Lawn Mower Housing on page 21.
2. Remove grass clippings, dirt, and grime from external
parts of the shrouding and from the top of the lawn
mower housing.
3. Check the condition of the blades; if necessary, replace
the blades. Refer to Replacing the Blades on page 23.
Important
Toro designed your lawn mower with a
built-in battery pack charger that checks the charging
status and charges the battery pack only when necessary.
Therefore, leave the battery pack plugged in whenever
you are not using the lawn mower during the mowing
season.
Important
During the off-season, keep the battery
pack fully charged, remove it from the lawn mower, and
store it in a cool place no colder than –4 F (–20 C). You
can store a fully charged battery pack for up to six months
before recharging if it is stored in a cool, dry place.
Charge the battery pack before using the lawn mower for
the first time of the season.
Accessories
Replacement Blades
Replacement Battery Pack
Battery Charger
Perimeter Switch
Pegs
Wire
Advertisement
Table of Contents
