Table of Contents
Advertisement
Clearing and resetting the CMOS
This section describes the steps necessary to successfully clear and reset the CMOS. The CMOS of the
computer stores password information and information about the computer configuration.
Using the CMOS button to reset CMOS
To clear CMOS using the Clear CMOS button, use the following procedure:
WARNING!
cord from the wall outlet and allow the internal system components to cool before touching them.
CAUTION:
When the computer is plugged in, the power supply has voltage applied to the system board,
even when the computer is powered off. Failure to disconnect the power cord can result in damage to the
system.
Static electricity can damage the electronic components of the computer or optional equipment. Before
beginning these procedures, be sure that you are discharged of static electricity by briefly touching a
grounded metal object.
1.
Back up your computer CMOS settings, run Computer Setup (f10) Utility, and select File > Save to Disk.
CAUTION:
customized information, including asset numbers and special settings.
2.
Shut down the operating system, power off the computer and external devices, and disconnect
peripheral devices.
3.
Disconnect the AC power cord from the power outlet.
NOTE:
4.
Open the workstation.
5.
Locate, press, and hold the CMOS button for five seconds.
For assistance locating the CMOS button and other system board components, see the system board
layout in
6.
Close the workstation, reconnect external devices, connect the power cord and turn on the workstation.
7.
The system boots to an f1 prompt and displays a message that the date/time has changed and that
system options have changed.
8.
Press f1. The system shuts down for three seconds and then powers on again.
9.
Use Computer Setup (f10) Utility to reset the date and time.
To reduce the risk of personal injury from electric shock and hot surfaces, disconnect the power
Pressing the Clear CMOS button resets CMOS values to factory defaults and erases
The CMOS button does not clear CMOS if the power cord is connected.
Hardware overview on page
1.
Clearing and resetting the CMOS
77
Advertisement
Table of Contents
Troubleshooting
