Resetting The Password Jumper - HP Z228 Maintenance And Service Manual

Resetting the password jumper

Use the following procedure to disable the power-on or setup password features and clear the power-on and
setup passwords.
WARNING!
disconnect the power cord from the wall outlet and allow the internal system components to cool before
touching them.
CAUTION:
even when the computer is turned off. Failure to disconnect the power cord can result in damage to the
system.
CAUTION:
Before beginning these procedures, be sure that you are discharged of static electricity by briefly touching a
grounded metal object.
1. Access the jumper:
a. Shut down the operating system, turn off the computer and external devices, and then disconnect
the computer power cord and external devices from power outlets.
b. Disconnect any external devices.
c. Verify that the AC power cord is disconnected from the power outlet.
d. Open the workstation.
e. Locate the password header and jumper.
The password header is PSWD. The password jumper is green so it can be easily identified.
2. Remove the jumper from pins 1 and 2. Do not lose the jumper.
3. Restart the computer:
a. Close the workstation.
b. Reconnect the AC power cord to the power outlet.
c. Turn on the computer and wait for the workstation to display the HP splash screen.
4. Repeat step 1.
5. Replace the jumper on pins 1 and 2.
6. Repeat step 3, except press the
7. Use the setup utility to create new passwords.
76 Chapter 6 Configuring password security and resetting CMOS
To reduce the risk of personal injury from electrical shock and hot surfaces, be sure to
When the computer is plugged in, the power supply has voltage applied to the system board,
Static electricity can damage the electronic components of the computer or optional equipment.
f10 key during startup to access Computer Setup (f10) Utility.