Parallel Interface Connection - Kyocera FS-6020 Installation Manual

Parallel Interface Connection

Parallel Printer
Cable
USB (Universal Serial Bus) Interface Connection
USB Cable
1
Plug one end of the printer cable (not
included) into the parallel interface con-
Clip
nector on the rear of the printer.
• Use a parallel printer cable
Clip
• The printer will work best if it
2
Close the clips on both sides to fix the
connector in place.
Plug the other end of the printer cable
into the computer's parallel interface
connector.
1
Plug one end of the USB cable on the
rear of the printer.
• Use a cable that complies
• The connecting cable should
2
Plug the other end of the USB cable into
the computer's USB interface connec-
tor.
that complies with the
IEEE1284 standards.
is installed near the computer.
The connecting cable should
be shielded and not be longer
than 3 meters (10 feet).
with Full-Speed USB 2.0 stan-
dard (a rectangular Type A
plug and a square Type B
plug).
be shielded and not be longer
than 5 meters (16 feet).
7