Vinten Vision 11 Maintenance Manual page 37

Contents
25.4 Hold the indicator (2) stationary and rotate the control knob to the right until drag begins to be
felt.
25.5 Turn the indicator to 2.
25.6 Turn the drag control knob (3) and indicator (2) together until the grub screw (4) is
accessible.Carefully tighten the grubscrew, adjusting the position of the control knob as necessary so
that the grub screw seats correctly in a slot in the indicator and may be screwed fully home.
25.7 Decrease drag to zero.
25.8 Increase drag and ensure that drag begins to be felt at about 1 on the indicator. Repeat the
above procedure until this can be achieved.
25.9 Adjust the tilt drag knob in a similar fashion, referring to
26 Install the battery and check the electrical system as follows:
26.1 Referring to
26.2 Position the battery in the battery housing (8), ensuring that the wiring is neatly stowed in the cut-
out provided.
26.3 Refit the battery cover (9).
26.4 Press the switch (7) and ensure that the balance mechanism digital display, the level bubble and
the drag knob scales are lit for approximately 15 seconds.
27 Carry out the balance mechanism digital display calibration
calibration" on page 26.).
Fig 6.6, push the connector (2G) onto the terminals of the battery (10).
First Previous
Page Page
Fig 6.4.
(See "Balance mechanism digital display
Next Previous
Page View
37