Assembly - Vinten Vision 11 Maintenance Manual

Contents
12.5 The digits cover (6) is secured to the mechanism housing (11) using Silcoset. Remove if
required.

Assembly

Electrical system
13 To install the electrical system
13.1 If removed, secure the LED housing (5) to the PCB mounting (2D) using Loctite 405. Position the
LED (2E) in the housing.
13.2 Secure the LED (2F) to the underside of the level bubble using Silcoset.
13.3 Pass the wiring up through the aperture in the mechanism housing (11) and position the PCB
(2C) in the cut-out. Install the PCB mounting (2D) and secure with three screws (4).
13.4 Push the push-button cap (7) onto the switch on the PCB mounting.
13.5 Position wires and secure with wiring retainer (13) in positions noted during disassembly.
13.6 The remaining components of the electrical system are installed later.
Pan unit assembly
14 To assemble the pan unit assembly
14.1 If removed, press the bearing (22) into the pan drag housing (9).
14.2 Lightly lubricate the 'O' ring (15) with LM grease and install on the shaft in the spherical base
(14).
14.3 Lightly lubricate the thrust bearing (11) with LM grease. With the pan drag housing upside-down,
install a thrust washer (10), the thrust bearing (11) and a second thrust washer (10).
14.4 Lightly lubricate the omniseal (20) with LM grease and install in the seal plate (19), ensuring
omniseal is correctly oriented.
14.5 Lightly lubricate the 'O' ring (18) with LM grease and install on the seal plate (19).
14.6 Push the assembled seal plate into position on the pan drag housing (9).
14.7 Install the drag shoe assembly (17) on the pan drag housing (9) and secure lightly with screw
(16), using Loctite 222E.
14.8 Position two drag wedges (12) and the drag actuator block (13) in the drag shoe assembly (17).
14.9 Screw the special thumb screw (3441-907TL) through the pan drag housing and into the drag
actuator block (13). Tighten the thumb screw until the drag shoe (17) begins to expand, then tighten
screw (16) fully, but do not overtighten. Unscrew the thumb screw slightly.
14.10 Thoroughly clean and degrease the brake drum on the spherical base (14).
(Fig 6.6):
(Fig 6.3):
First Previous Next
Page Page Page
Previous
View
32