Warnings - Viking DSOE301SS Service Manual

General Information General Information

Warnings

Read and follow all instructions before using this
appliance to prevent the potential risk of fire,
electric shock, personal injury, or damage to the
appliance as a result of improper usage of the
appliance. Use appliance only for its intended
purpose as described in this manual.
To ensure proper and safe operation: appliance
must be properly installed and grounded by a
qualified technician. DO NOT attempt to adjust,
repair, service, or replace any part of your appliance
unless it is specifically recommended in this manual.
All other servicing should be referred to a qualified
servicer.
Electrical Requirements
Check your national and local codes regarding
this unit.
WARNING
To avoid risk of property damage, personal
injury or death, follow information in this
manual exactly to prevent a fire or explosion.
240V (AC), 50 amp service with its own circuit
breaker.
with the rating of the appliance and to the
requirements of the National Electrical Code,
ANSI/NFPA 70 – latest edition, or Canadian
Electrical Code, CSA C22.1-1982 and C22.2
No. 01982 – latest edition, and all local codes
and ordinances.
electrical voltage and frequency as specified
on the model/serial rating plate (located under
right side of control panel).
permanent wiring system. Check with a
qualified electrician to make sure the oven is
properly grounded.
DO NOT ground to a gas pipe.
DO NOT use an extension cord with this
appliance, because this may result in electrical
shock or other personal injury.
in the conduit.
© 2010 Viking Preferred Service
top left for a flush installation. NEVER cut
the conduit.
to 4-wire, 240V household service. If codes
permit and separate grounding wiring is used,
we recommend that a qualified electrician
determine the grounding path and that the
wire gauge is in accordance with local codes.
directly behind oven must be recessed
and located at the upper left-hand corner
of the cabinet.
provided at the junction box.
DO NOT install a fuse in the neutral or
grounding circuit. We recommend a time
delayed fuse or circuit breaker. Connect directly
to the fused disconnect (or circuit breaker
box) through flexible armored, or non-metallic
sheathed, copper cable (with grounding wire).
Cleaning Safety
to cool before touching or cleaning them.
steam burns if a wet sponge or cloth is used
to wipe spills on a hot surface. Some cleaners
can produce noxious fumes if applied to a hot
surface.
Self-Clean Oven
clean door gasket. The door gasket is essential
for a good seal. Care should be taken not to
rub, damage, or move the gasket. DO NOT
use oven cleaners of any kind in or around any
part of the self-clean oven.
pan, racks, and other utensils and wipe up
excessive spill-overs to prevent excessive
smoke or flaming.
operates automatically during a clean cycle.
If the fan does not turn on, cancel the clean
operation and contact an authorized servicer.
DO NOT
8 8