Diagnostics; Diagnostic Procedures; User Settings; Degrees - Viking DSOE301SS Service Manual

Diagnostics

Diagnostic Procedures

The DSOE301, DDOE301, and DDOE305 use the same clock (TOD2) but because of the programming, the
actual buttons are labeled differently on the control panel. Below are examples showing both clocks.
DSOE301/DDOE301
DDOE305
DSOE301/DDOE301
DDOE305
For the following procedures, the clock from the DSOE301/DDOE301 is being used as the example. In this
manual, we will refer to (from left to right) Button 1 —Button 2—(SET KNOB)—Button 3 and Button 4.
1 2 3 4
SET
1 2 3 4
SET

User Settings

To enter into Settings parameter, press and hold "BuTTON 1" for three seconds. When the Settings mode is
entered, the clock display will change to the first parameter (Temperature). To exit the Settings mode, press
"BuTTON 2".
Note: Settings mode will automatically exit the Settings mode if nothing is pressed within 60 seconds.

Degrees

The "F" indicates that the unit is set to display fahrenheit (below left). To change to celsius, depress
"BuTTON 1". The unit set for celsius is shown (below right).
16
© 2010 Viking Preferred Service