Table of Contents
Advertisement
1
Figure 42
1. Air cleaner cover
2. Air cleaner filter
3. Air cleaner indicator
4. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the cover,
clean the cavity and replace the outlet valve.
5. Install the cover orienting the rubber outlet valve in a
downward position—between approximately 5:00 to
7:00 when viewed from the end.
6. Secure the latches.
Servicing the Engine Oil and
Filter
Change the engine oil and filter initially after the first 50 hours
of operation and every 150 hours thereafter.
1. Remove the drain plug (Figure 43) and let the oil flow
into a drain pan.
Figure 43
1. Oil drain plug
2. When the oil stops, install the drain plug.
3. Remove the oil filter (Figure 44).
2
g021218
3
1. Oil filter
4. Apply a light coat of clean oil to the new filter seal.
5. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn.
Important: Do not over-tighten the filter.
6. Add oil to the crankcase; refer to Checking the Engine
Oil.
Adjusting the Throttle
1. Position the throttle lever forward so it is approximately
3 mm (1/8 inch) from the front of the control arm slot.
2. Loosen the throttle cable connector, on the throttle
cable, next to the injection pump lever (Figure 45).
1. Throttle cable pivot
2. Injection pump lever arm
3. Hold the injection pump lever arm against the high
idle stop (Figure 45).
40
Figure 44
Figure 45
3. High idle stop
4. Throttle cable connector
Advertisement
Table of Contents
