Table of Contents
Advertisement
2. Slide the scraper up or down until a gap of 0.5 to 1
mm (0.020 to 0.040 inch) is achieved between the rod
and the roller.
3. Secure the grease fitting and screw to 41 N-m (30 ft-lb)
in an alternating sequence.
11
Installing the Mulching Baffle
(Optional)
No Parts Required
Procedure
1. Thoroughly clean debris from the mounting holes on
the rear wall and left side wall of the chamber.
2. Install the mulching baffle in the rear opening and
secure it with 5 flange head bolts (Figure 12).
Figure 12
1. Mulching baffle
3. Verify that mulching baffle does not interfere with
the tip of the blade and does not protrude inside the
surface of the rear chamber wall.
WARNING
Do not use the high lift blade with the
mulching baffle. The blade could break,
resulting in personal injury or death.
1
G011347
Product Overview
Controls
Seat Adjusting Knobs
The seat adjusting lever (Figure 13) allows you to adjust the
seat fore and aft. The weight adjusting knob adjusts the seat
for the operator's weight. The weight gauge indicates when
the seat is adjusted to the weight of the operator. The height
adjusting knob adjusts the seat for the operator's height.
1. Weight gauge
2. Weight adjusting knob
Traction Pedal
The traction pedal (Figure 14) controls the forward and
reverse operation. Press the top of the pedal to move forward
and the bottom to move rearward. Ground speed depends on
how far you press the pedal. For no load, maximum ground
speed, fully press the pedal while the throttle is in the Fast
position.
To stop, reduce foot pressure on the traction pedal and allow
it to return to the center position.
Mow Speed Limiter
When the mow speed limiter (Figure 14) is flipped up it will
control the mow speed and allow the cutting decks to be
engaged. Each spacer adjusts the mowing speed by ½ mile
per hour. The more spacers you have, on the top of the bolt
the slower you will go. For transport, flip back the mow speed
limiter and you will have maximum transport speed.
Brake Pedal
Press the brake pedal (Figure 14) to stop the machine.
Parking Brake
To engage the parking brake, (Figure 14) push down on the
brake pedal and press the top forward to latch. To release the
19
Figure 13
3. Height adjusting knob
4. Adjusting lever (fore and
aft)
Advertisement
Table of Contents
