Toro 30853 Operator's Manual page 23

Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
Engine Run
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
The Diagnostics menu
displays the state of each
machine switch, sensor, and
control output. You can use
this to troubleshoot certain
issues as it will quickly tell you
which machine controls are on
and which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode.
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Protected Menus
Counterbalance
* Only "operator-faced" text is translated. Faults, Service, and
Diagnostics screens are "service-faced". Titles will be in the
selected language, but menu items are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There is 1 operating configuration setting that is adjustable
within the Settings Menu of the InfoCenter: counterbalance.
This setting can be locked by using the Protected Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
Accessing the Protected Menu Settings
To access the Protected Menu Settings
•
From the Main Menu, scroll down to the Settings Menu
and press the right button.
•
In the Settings Menu, scroll down to the Protected Menu
and press the right button.
•
To enter the passcode, use the center button to set the
first digit then press the right button to move on to the
next digit.
•
Use the center button to set the second digit then press
the right button to move on to the next digit.
•
Use the center button to set the third digit then press the
right button to move on to the next digit.
•
Use the center button to set the fourth digit then press
the right button.
•
Press the middle button to enter the code.
•
If the code has been accepted and the protected menu has
been "Unlocked", "PIN" will be displayed in the upper
right corner of the display screen.
The ability to view and change the settings in the Protected
Menu can be changed. Once the Protected Menu has been
23
Allows the
superintendant/mechanic
to access protected menus by
inputting a passcode.
Controls the amount of
counterbalance applied to the
cutting decks.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.