1. Traction manifold
2. Spacers
3. Bolts
4. Washers
•
Remove the 3 bolts, washers, and spacers securing the traction manifold to the bottom of the rear bumper (Figure 4a).
•
Position the appropriate amount of weight on the top and/or bottom of the rear bumper.
•
Mount the weight(s) and the traction manifold to the bumper with the 3 bolts, washers and spacers previously removed
(Figure 4b).
Note: Do not use the spacers when installing more than two weights under the bumper (Figure 4c).
•
Secure the outer edges of the weight(s) to the bumper with 2 carriage bolts and nuts (Figure 4c).
6
Installing the Hood Latch for
CE Compliance
Parts needed for this procedure:
1
Hood latch assembly
1
Washer
Procedure
1. Unlatch and raise the hood.
2. Remove the rubber grommet from the hole in the left
side of the hood (Figure 5).
Figure 4
5. Weight(s)
6. Carriage bolt
7. Nut
1. Rubber grommet
3. Remove the nut from the hood latch assembly (Figure
6).
16
Figure 5