Specifications; Attachments/Accessories; Operation; Checking The Engine Oil Level - Toro 30853 Operator's Manual

accessed, scroll down to Protect Settings. Using the right
button, changing Protect Settings to OFF will allow the
ability to view and change the settings in the Protected Menu
without entering the passcode. Changing Protect Settings to
ON will hide the protected options and will require entering a
passcode to change the setting in the Protected Menu. After
the pass code has been set, the key switch must be turned off
and back on to enable and save this feature.
Note: If the passcode has been forgotten or misplaced,
please contact your distributor for assistance.
To Set the Counterbalance
•
In the Settings Menu, scroll down to Counterbalance.
•
Press the right button to select counterbalance and
change between the low, medium, and high settings.

Specifications

Note: Specifications and design are subject to change
without notice.
Transport Width
Width of cut
Length
Height
Net weight*
Fuel tank capacity
Transport speed
Mowing speed
* With cutting decks and fluids
Cutting Deck
Length
Width
Height
Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
226 cm (89 inches)
229 cm (90 inches)
320 cm (126 inches)
218 cm (86 inches)
1,412 kg (3,114 lb)
53 liters (14 US gallons)
0–16 kph (0–10 mph)
0–13 kph (0–8 mph)
86.4 cm (34 inches)
86.4 cm (34 inches)
24.4 cm (9.6 inches)
to carrier mount
26.7 cm (10–1/2 inches)
at 3/4 inch height of cut
34.9 cm (13–3/4 inches) at
4 inch height of cut
88 kg (195 pounds)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Lower the cutting decks to the ground, set the
parking brake and remove the key from the ignition
switch before servicing or making adjustments to
the machine.

Checking the Engine Oil Level

The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started.
Crankcase capacity is approximately 5.2 liters (5.5 quarts)
with the filter.
Use high-quality engine oil that meets the following
specifications:
•
API Classification Level Required: CH-4, CI-4 or higher
•
Preferred oil: SAE 15W-40 (above 0 degrees F)
•
Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
Toro Premium Engine oil is available from your distributor in
either 15W-40 or 10W-30 viscosity.
1. Park the machine on a level surface, stop the engine,
set the parking brake and remove the key from the
ignition switch.
2. Open the hood.
3. Remove the dipstick, wipe it clean, and install it (Figure
19).
24