Table of Contents
Advertisement
3.
Secure the grease fitting and screw to 41 N-m
(30 ft-lb) in an alternating sequence.
7
Installing the Mulching
Baffle (Optional)
No Parts Required
Procedure
1.
Thoroughly clean debris from the mounting
holes on the rear wall and left side wall of the
chamber.
2.
Install the mulching baffle in the rear opening
and secure it with 5 flange head bolts
1. Mulching baffle
3.
Verify that mulching baffle does not interfere with
the tip of the blade and does not protrude inside
the surface of the rear chamber wall.
WARNING
Do not use the high lift blade with the
mulching baffle. The blade could break,
resulting in personal injury or death.
(Figure
Figure 7
Product Overview
Controls
Seat Adjusting Knobs
The seat adjusting lever
adjust the seat fore and aft. The weight adjusting
knob adjusts the seat for the operator's weight. The
weight gauge indicates when the seat is adjusted to
the weight of the operator. The height adjusting knob
adjusts the seat for the operator's height.
7).
1. Weight gauge
2. Weight adjusting knob
Traction Pedal
The traction pedal
reverse operation. Press the top of the pedal to move
g011347
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
Mow Speed Limiter
When the mow speed limiter
will control the mow speed and allow the cutting decks
to be engaged. Each spacer adjusts the mowing
speed by ½ mile per hour. The more spacers you
have, on the top of the bolt the slower you will go. For
transport, flip back the mow speed limiter and you will
have maximum transport speed.
15
(Figure
8) allows you to
Figure 8
3. Height adjusting knob
4. Adjusting lever (fore and
aft)
(Figure
9) controls the forward and
(Figure
9) is flipped up it
g003954
Advertisement
Table of Contents
