Figure 13
1. Carrier Frame
2. Hairpin Cotter
3. Back height-of-cut post
Adjusting the Anti-Scalp
Rollers
The anti-scalp rollers need to be adjusted in the proper hole
location for each height-of-cut position. There needs to be
3/8 inch (10 mm) minimum clearance above the ground.
Note: If the anit-scalp rollers are adjusted too low can cause
excess wear of the rollers.
1. After adjusting height-of-cut, check the anti-scalp
rollers so that there is a minimum of 3/8 inch (10 mm)
clearance above the ground (Figure 14).
2. If adjustment is needed, remove the bolt, washers and
nut (Figure 14).
3. Select a hole position so the anti-scalp rollers are
a minimum of 3/8 inch (10 mm) off the ground
(Figure 14).
4. Install the bolt and nut (Figure 14).
4. Spacers
5. Front height-of-cut post
1. Mower deck
2. Bolt
3. Spacer
Adjusting the Handle Height
The handle position can be adjusted to match the operator's
height preference.
1. Remove hairpin cotter, washer and clevis pin securing
control rod fitting to idler bracket (Figure 15).
1. Control rod and fitting
2. Idler bracket
3. Clevis pin
2. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Figure 16).
18
Figure 14
4. Anti-Scalp Rollers
5. Nut
Figure 15
4. Washer
5. Hairpin cotter pin
6. Rod fitting