Storage; Cleaning And Storage - Toro 30070 Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the shift lever plate, and engine.
3. Check the brake; refer to Servicing the Brake in
Brake Maintenance (page 31).
4. Service the air cleaner; refer to Servicing the Air
Cleaner in Engine Maintenance (page 23).
5. Grease the machine; refer to Greasing and Lubrication
in Lubrication (page 21).
6. Change the engine oil; refer to Servicing the Engine in
Engine Maintenance (page 23).
7. Check the tire pressure; refer to Checking the Tire
Pressure in Drive System Maintenance (page 28).
8. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel
tank; refer to Servicing the Fuel Tank in
Fuel System Maintenance (page 26), or operate
engine until it stops.
D. Restart engine and run until it stops. Repeat, on
Choke until engine will not restart.
E. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
9. Remove the spark plug(s) and check its
condition; refer to Servicing the Spark Plug in
Engine Maintenance (page 23). With the spark plug(s)
removed from the engine, pour two tablespoons of
engine oil into the spark plug hole. Now use the starter
to crank the engine and distribute the oil inside the
cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
12. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
41