Toro 30070 Operator's Manual page 37

4. At the carrier frame cross channel, measure the height
at location A (Figure 52). This measurement must be
1-5/16 inch (33 mm), plus or minus a 1/4 inch (6 mm).
5. If the height at location A is not correct, adjustment
is needed.
6. Loosen the carrier frame mounting bolts on both sides
of the machine (Figure 52).
7. Align the carrier frame and engine deck to match
1-5/16 inch (33 mm), plus or minus a 1/4 inch (6 mm)
at location A (Figure 52).
8. Tighten the carrier frame mounting bolts on both sides
of the machine.
1. Carrier Frame
2. Top of engine deck
3. Carrier frame mounting
bolts
Checking the Engine Deck Height
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the tire pressure in the rear tires to specifications;
refer to Drive System Maintenance (page 28) .
4. Measure engine deck height at location A (Figure 53).
Figure 52
4. Location A, 1-5/16 inch
(33 mm) ±1/4 inch (6 mm)
5. Straight edge
6. Carrier frame cross
channel
1. Back view of machine
2. Top of engine deck
5. Measure engine deck height at location B (Figure 53).
6. If the height at location A and B are not the same,
change tire pressure slightly to make them the same.
37
Figure 53
3. Tires
4. Same height at locations
A and B