Replacing the Fuel Filter
Service Interval: Every 200 hours/Yearly (whichever comes
first)
Never install a dirty filter if it is removed from the fuel line.
Note: Note how the fuel filter is installed.
Note: Wipe up any spilled fuel.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Close fuel shut-off valve at fuel tank (Figure 31).
Note: Remove the fuel line from the fuel valve that is
closest to the engine.
4. Squeeze the ends of the hose clamps together and slide
them away from the filter (Figure 32).
Figure 32
1. Hose clamp
2. Fuel line
5. Remove the filter from the fuel lines.
6. Install a new filter and move the hose clamps close to
the filter.
7. Open fuel shut-off valve at fuel tank (Figure 31).
8. Check for fuel leaks and repair if needed.
3. Filter
Electrical System
Maintenance
Servicing the Fuse
The electrical system is protected by a fuse. It requires no
maintenance. If the fuse blows check component or circuit
for malfunction or short. To replace fuse pull out on the fuse
(Figure 33) to remove or replace it.
1. Fuse, 7.5 amp, blade type
27
Figure 33