Table of Contents
Advertisement
2
Adjusting the Step Height
No Parts Required
Procedure
The height of the steps can be adjusted for the operators
comfort.
1. Remove the 2 bolts and nuts securing the step brackets
to the traction unit frame
1. Step
2. Raise or lower the step to the desired height and
re-secure the brackets to the frame with the 2 bolts
and nuts.
3. Repeat the procedure on the other step.
3
Adjusting the Control Arm
Position
No Parts Required
Procedure
The control arm position can be adjusted for the operators
comfort.
1. Loosen the 2 bolts securing the control arm to the
retaining bracket
(Figure
(Figure
2)
Figure 2
2. Step brackets
3).
1. Control arm
2. Retaining brackets
2. Rotate the control arm to the desired position and
tighten the 2 bolts.
4
Installing the Cutting Units
Parts needed for this procedure:
5
Cutting units
Procedure
CAUTION
If you do not disconnect the power to the cutting
units, someone could accidentally start the cutting
unit, causing serious injury to hands and feet.
Always separate the cutting unit power disconnect
connectors before working on the cutting units
(Figure
26).
1. Disconnect the cutting unit power disconnect
connector; refer to Cutting Unit Power Disconnect in
the Product Overview section.
2. Remove the cutting units from the cartons. Assemble
and adjust as described in the cutting unit Operator's
Manual.
3. Make sure the counter weight
the proper end of the cutting unit as described in the
counter weight kit Installation Instructions.
12
Figure 3
3. Bolts (2)
(Figure
4) is installed to
Advertisement
Table of Contents
