Toro 03674 Operator's Manual page 13

G027133
1
Figure 4
1. Counter weight
4. All the cutting units are shipped with the turf
compensation spring mounted to the right side of the
cutting unit. The turf compensation spring must be
mounted to the same side of the cutting unit as the
reel drive motor. Reposition the turf compensation
as follows:
A. Remove the 2 carriage bolts and nuts securing the
rod bracket to the cutting unit tabs
Figure 5
1. Turf compensation spring
2. Rod bracket
B. Remove the flange nut securing the spring tube
bolt to the carrier frame tab
the assembly.
C. Mount the spring tube bolt to the opposite tab on
the carrier frame and secure with the flange nut.
The bolt head is to be positioned to the outer side
of the tab as shown in
(Figure 5).
3. Spring tube
(Figure 5) Remove
Figure 6.
1. Opposite carrier frame tab
D. Mount the rod bracket to the cutting unit tabs
with the carriage bolts and nuts
Note: When installing or removing the cutting
units, make sure the hairpin cotter is installed
in the spring rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
5. Lower all the lift arms completely.
6. Remove the snapper pin and the cap from the lift arm
pivot yoke (Figure
1. Snapper pin
7. For the front cutting units, slide a cutting unit under
the lift arm while inserting the carrier frame shaft up
into the lift arm pivot yoke
13
Figure 6
2. Rod bracket
(Figure
7).
Figure 7
2. Cap
(Figure 8).
6).