Toro 03674 Operator's Manual page 23

Engine Run
Backlap
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Front Backlap Reel Speed
Rear Backlap Reel Speed
Protected Menus
Auto Idle
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
Economy Mode
* Only "operator-faced" text is translated. Faults, Service, and
Diagnostics screens are "service-faced". Titles will be in the
selected language, but menu items are in English.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.
Indicates the inputs, qualifiers
and outputs for operating the
backlap function.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Controls the speed of the front
reels in backlap mode.
Controls the speed of the rear
reels in backlap mode.
Allows the
superintendant/mechanic
to access protected menus by
inputting a passcode.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary.
Controls the number of blades
on the reel for reel speed.
Controls the ground speed for
determining the reel speed.
Controls the height of cut
(HOC) for determining the reel
speed.
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted.
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted.
When activated, the Economy
Mode lowers the engine
speed while mowing to reduce
noise and fuel consumption.
The reel speed does not
change, but the mow speed is
decreased if the mow stop is
not adjusted accordingly.
About
Menu Item
Model
SN
Machine Controller Revision
CU 1
CU 2
CU 3
CU 4
CU 5
Generator
InfoCenter Revision
CAN Bus
Protected Menus
There are 2 additional display screens and 7 operating
configuration settings that are adjustable within the Settings
Menu of the InfoCenter: Auto Idle, Blade Count, Mow
Speed, Height of Cut (HOC), F Reel RPM, R Reel RPM and
Economy Mode. These settings can be locked by using the
Protected Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
Accessing the Protected Menu Settings
and Display Screens
To access the Protected Menu Settings and Display Screens
•
From the Main Menu, scroll down to the Settings Menu
and press the right button.
•
In the Settings Menu, scroll down to the Protected Menu
and press the right button.
•
To enter the passcode, use the center button to set the
first digit then press the right button to move on to the
next digit.
•
Use the center button to set the second digit then press
the right button to move on to the next digit.
•
Use the center button to set the third digit then press the
right button to move on to the next digit.
•
Use the center button to set the fourth digit then press
the right button.
•
Press the middle button to enter the code.
•
If the code has been accepted and the protected menu has
been "Unlocked", "PIN" will be displayed in the upper
right corner of the display screen.
23
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
each cutting unit
Lists the software revision of
the motor/generator
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.