Toro 03674 Operator's Manual page 14

1. Lift arm
2. Carrier frame shaft
8. Use the following procedure on the rear cutting units
when the height of cut is above 3/4 inch.
A. Remove the lynch pin and washer securing the lift
arm pivot shaft to the lift arm and slide the lift
arm pivot shaft out of the lift arm
1. Lift arm pivot shaft lynch pin and washer
B. Insert the lift arm yoke onto the carrier frame
shaft (Figure 8).
C. Insert the lift arm shaft into the lift arm and
secure it with the washer and lynch pin
9. Insert the cap over the carrier frame shaft and lift arm
yoke.
10. Secure the cap and the carrier frame shaft to the lift
arm yoke with the snapper pin. Use the slot if a steering
cutting unit is desired or use the hole if the cutting unit
is to be locked in position
11. Secure the lift arm chain to the chain bracket with the
snapper pin (Figure
described in the cutting unit Operator's Manual.
Figure 8
3. Lift arm pivot yoke
(Figure
Figure 9
(Figure
(Figure 7).
10). Use the number of chain links
1. Lift arm chain
12. Coat the spline shaft of the reel motor with clean
grease.
13. Oil the reel motor O-ring and install it onto the motor
flange.
14. Install the motor by rotating it clockwise so that the
motor flanges clear the bolts
motor counterclockwise until the flanges encircle the
bolts then tighten the bolts.
Important: Make sure the reel motor hose is not
twisted, kinked or in the risk of being pinched.
9).
9).
1. Reel drive motor
14
Figure 10
2. Chain bracket
(Figure 11). Rotate the
g027140
2 1
Figure 11
2. Mounting bolt (2)