Maintenance And Storage - Toro 03674 Operator's Manual

Traction unit
Hide thumbs Also See for 03674:
Table of Contents

Advertisement

Remember there is no such thing as a safe slope. Travel
on grass slopes requires particular care. To guard against
overturning:
– do not stop or start suddenly when going up or
downhill;
– machine speeds should be kept low on slopes and
during tight turns;
– stay alert for humps and hollows and other hidden
hazards;
– Do not turn sharply. Use care when reversing.
– Use counterweight(s) or wheel weights when
suggested in the operator's manual.
Stay alert for holes in the terrain and other hidden hazards.
Watch out for traffic when crossing or near roadways.
Stop the blades rotating before crossing surfaces other
than grass.
When using any attachments, never direct discharge of
material toward bystanders nor allow anyone near the
machine while in operation.
Never operate the machine with damaged guards, shields,
or without safety protective devices in place. Be sure all
interlocks are attached, adjusted properly, and functioning
properly.
Do not change the engine governor settings or over-speed
the engine. Operating the engine at excessive speed may
increase the hazard of personal injury.
Before leaving the operator's position:
– stop on level ground;
– disengage the power take-off and lower the
attachments;
– change into neutral and set the parking brake;
– stop the engine and remove the key.
Disengage drive to attachments when transporting or not
in use.
Stop the engine and disengage drive to attachment:
– before refuelling;
– before removing the grass catcher/catchers;
– before making height adjustment unless adjustment
can be made from the operator's position.
– before clearing blockages;
– before checking, cleaning or working on the mower;
– after striking a foreign object or if an abnormal
vibration occurs. Inspect the mower for damage
and make repairs before restarting and operating the
equipment.
Reduce the throttle setting during engine run-out and, if
the engine is provided with a shut-off valve, turn the fuel
off at the conclusion of mowing.
Keep hands and feet away from the cutting units.
Look behind and down before backing up to be sure of
a clear path.
Slow down and use caution when making turns and
crossing roads and sidewalks. Stop cylinders/reels if not
mowing.
Do not operate the mower under the influence of alcohol
or drugs.
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
Use care when loading or unloading the machine into a
trailer or truck.
Use care when approaching blind corners, shrubs, trees,
or other objects that may obscure vision.
Rollover Protection System (ROPS) -
Use and Maintenance
The ROPS is an integral and effective safety device. Keep
a folding ROPS in the raised and locked position and use
the seat belt when operating the machine.
Lower a folding ROPS temporarily only when absolutely
necessary. Do not wear the seat belt when folded down
Be aware there is no rollover protection when a folded
ROPS is in the down position.
Be certain that the seat belt can be released quickly in
the event of an emergency.
Check the area to be mowed and never fold down a
folding ROPS in areas where there are slopes, drop offs
or water
Check carefully for overhead clearances (i.e. branches,
doorways, electrical wires) before driving under any
objects and do not contact them
Keep the ROPS in safe operating condition by
periodically thoroughly inspecting for damage and
keeping all mounting fasteners tight.
Replace a damaged ROPS. Do not repair or revise.
Do not remove the ROPS.
Any alterations to a ROPS must be approved by the
manufacturer.

Maintenance and Storage

Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
Never store the equipment with fuel in the tank inside a
building where fumes may reach an open flame or spark.
Allow the engine to cool before storing in any enclosure.
To reduce the fire hazard, keep the engine,
silencer/muffler, battery compartment and fuel storage
area free of grass, leaves, or excessive grease.
Check the grass catcher frequently for wear or
deterioration.
Keep all parts in good working condition and all hardware
and hydraulic fittings tightened. Replace all worn or
damaged parts and decals.
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Reelmaster 5010-h

Table of Contents