Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
CE Certificate
Operator Training Material
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Adjusting the Tire Pressure
No Parts Required
Procedure
The tires are over-inflated for shipping. Therefore, release
some of the air to reduce the pressure. Correct air pressure in
the front and rear tires is 12 to 15 psi (83 to 103 kPa).
Important: Maintain even pressure in all tires to ensure
uniform contact with the turf.
Description
No parts required
No parts required
No parts required
No parts required
Rear weights (quantity varies with
configuration).
Hood latch assembly
Washer
Throttle stop
Set screw
Qty.
–
–
–
–
Varies
1
1
1
1
Qty.
1
1
1
Review before operating machine
1
1
2
Adjusting the Step Height
No Parts Required
Procedure
The height of the steps can be adjusted for the operators
comfort.
1. Remove the 2 bolts and nuts securing the step brackets
to the traction unit frame (Figure 2)
11
Use
Adjust the tire pressure.
Adjust the step height.
Adjust the control arm position.
Remove shipping blocks and pins
Install rear weights (order from your
Toro Distributor).
Install the hood latch for CE compliance
Install the throttle stop for CE compliance
Use
Advertisement
Table of Contents
