Replacing The Hydraulic Filter; Checking The Hydraulic Lines And Hoses; Hydraulic System Test Ports - Toro 03674 Operator's Manual

Traction unit
Hide thumbs Also See for 03674:
Table of Contents

Advertisement

Replacing the Hydraulic Filter

Important: Use of any other filters may void the
warranty on some components.
1. Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking brake,
and remove the key from the ignition switch.
2. Clean the area around the filter mounting area and
place a drain pan under filter
1
Figure 72
1. Hydraulic filter
3. Remove the filter.
4. Lubricate the gasket on the new filter with hydraulic oil.
5. Ensure that the filter mounting area is clean.
6. Install the filter by hand until the gasket contacts the
mounting surface, then rotate it an additional 1/2 turn.
7. Start the engine and let it run for about two minutes to
purge air from the system.
8. Stop the engine and check for leaks.
Checking the Hydraulic Lines
and Hoses
Daily, check hydraulic lines and hoses for leaks, kinked
lines, loose mounting supports, wear, loose fittings, weather
deterioration, and chemical deterioration. Make all necessary
repairs before operating.
(Figure
72).
g027138
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure all hydraulic fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
• Get immediate medical help if fluid is injected
into skin.

Hydraulic System Test Ports

Use the hydraulic system test ports to test the pressure in
the hydraulic circuits. Contact your local Toro distributor for
assistance.
Use the test ports on the front hydraulic tubes
assist in troubleshooting the traction circuit.
1. Traction circuit test port
Use the test port on the gear pump
troubleshooting the lift circuit.
49
(Figure
Figure 73
(Figure
74) to assist in
73) to

Advertisement

Table of Contents
loading

This manual is also suitable for:

Reelmaster 5010-h

Table of Contents