Installing The Grass-Basket Hooks; Installing The Cutting Units - Toro 04510 Operator's Manual

6
Installing the Grass-Basket
Hooks
Parts needed for this procedure:
6 Grass-basket hook
12 Flange bolts
Procedure
Install the 6 grass-basket hooks onto the ends of the
suspension-arm bars using the 12 flange bolts
1. Flange bolt
2. Grass-basket hook
7

Installing the Cutting Units

Parts needed for this procedure:
1 Gauge bar
3 Cutting unit (model 04613, 04614, or 04615)
3 Grass Basket
Procedure
Note: When sharpening, setting the height-of-cut, or
performing other maintenance procedures on the cutting
units, store the cutting unit reel motors in the storage location
on the front of the suspension arms to prevent damage to
them.
(Figure
Figure 9
3. Suspension-arm bar
Important: Do not raise the suspension to the transport
position when the reel motors are in the holders in the
machine frame. Damage to the motors or hoses could
result.
Important: Whenever the cutting unit has to be tipped
to expose bedknife/reel, prop up rear of cutting unit to
make sure nuts on back end of bedbar adjusting screws
are not resting on work surface
9).
g014596
1. Prop (not provided)
Note: All cutting units are shipped with the counter weight
mounted to the right end and the motor mount and drive
coupler mounted to the left end of the cutting unit.
1. Apply grease to the inside diameter of the drive coupler.
2. The cutting unit is shipped without a front roller.
Obtain a roller (Models 04625, 04626, or 04627) from
your local Toro Distributor. Install the roller using
the loose parts supplied with the cutting unit and
installation instructions included with the roller.
3. If installing the center cutting unit, lift up on the foot
rest and swing it up, allowing access to the center
cutting unit position
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
15
(Figure 10).
2
2
1
Figure 10
2. Bedknife adjusting screw
nut (2)
(Figure 11).