Installing The Grass Basket Hooks; Installing The Cutting Units - Toro Greensmaster TriFlex 3400 Series Operator's Manual

6
Installing the Grass Basket
Hooks
Parts needed for this procedure:
6 Grass basket hook
12 Flange bolts
Procedure
Install the 6 grass basket hooks onto the ends of the
suspension arm bars using 12 flange bolts
1. Flange bolt
2. Grass basket hook
7

Installing the Cutting Units

Parts needed for this procedure:
1 Gauge bar
3 Cutting unit (model 04613, 04614, or 04615)
3 Grass Basket
Procedure
Note:
When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
(Figure
Figure 8
3. Suspension arm bar
storage location on the front of the suspension arms
to prevent damage to them.
Important:
Do not raise the suspension to the
transport position when the reel motors are in
the holders in the machine frame. Damage to the
motors or hoses could result.
Important:
Whenever the cutting unit has to be
tipped to expose bedknife/reel, prop up rear of
cutting unit to make sure nuts on back end of
bedbar adjusting screws are not resting on work
surface (Figure
8).
1. Prop (not provided)
Note:
All cutting units are shipped with the counter
weight mounted to the right end and the motor mount
g015492
and drive coupler mounted to the left end of the
cutting unit.
1. Apply grease to the inside diameter of the drive
coupler.
2. The cutting unit is shipped without a front roller.
Obtain a roller (Model No. 04625, 04626 or
04627) from your local Toro Distributor. Install
the roller using the loose parts supplied with the
cutting unit and installation instructions included
with the roller.
3. If installing the center cutting unit, lift up on the
foot rest and swing it up, allowing access to the
center cutting unit position
CAUTION
The foot rest can pinch fingers if it falls
into the closed position.
Keep your fingers clear of the area where
the foot rest seats while it is open.
16
9).
Figure 9
2. Bedknife adjusting screw
nut (2)
(Figure
g014596
10).