Toro 04510 Operator's Manual page 27

Note: A "click" can be heard and felt when the latches
are properly locked in place.
5. Coat the spline shaft of the cutting unit motor with
clean grease (Figure
6. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure
1
1. Reel motor
2. Spline shaft
7. Mount a grass basket onto the basket hooks on the
suspension arm.
8. Repeat this procedure for the other cutting units.
Removing the Cutting Units
1. Park the machine on a clean level surface, lower
the cutting units to the ground until the suspension
hydraulics are fully extended, stop the engine, and set
the parking brake.
35).
35).
2 3
Figure 35
3. Cavity
4. Motor-retaining bar
2. Push the motor retaining bar out of the slots on the
motor towards the cutting unit and remove the motor
from the cutting unit.
1
4
1. Reel motor
3. Move the motor to the storage location on the front of
the suspension arm
Note: When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
g014690
storage location on the front of the suspension arms to
prevent damage to them.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
holders in the machine frame. Damage to the
motors or hoses could result. If you must move the
traction unit without the cutting units installed,
secure them to the suspension arms using cable
ties.
4. Open the latches on the suspension-arm bar of the
cutting unit you are removing
5. Disconnect the latches from the cutting-unit bar.
6. Roll the cutting unit out from under the suspension
arm.
27
2
Figure 36
2. Motor-retaining bar
(Figure 37).
Figure 37
(Figure 33).
g014605
g014608