Installing And Removing The Cutting Units - Toro 04510 Operator's Manual

3. Insert a clean rod or screwdriver into the tank neck and
gently push down on the switch float
alarm should sound after the one-second delay.
1. Clean rod or screwdriver
2. Press down on the switch
4. Release the float.
Note: The alarm should stop sounding.
5. Install the strainer screen and hydraulic tank cap. Move
the ignition switch to the Off position.
Installing and Removing the
Cutting Units
Installing the Cutting Units
1. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
(Figure
Figure 31
3. Warning buzzer
(Figure
31). The
1. Footrest—closed
2. Position the cutting unit under the center suspension
arm.
3. With the latches on the suspension-arm bar pointing
up (i.e., open)
down so that the bar fits over the bar across the top of
the cutting unit
1. Latch—closed position
2. Suspension-arm bar
32).
1
2
1. Suspension-arm bar
4. Close the latches down and around the cutting-unit bar
and lock them in place
26
1
Figure 32
2. Footrest—open
(Figure 33), push the suspension arm
(Figure 34).
1
2
Figure 33
3. Latch—open position
Figure 34
2. Cutting-unit bar
(Figure 33).
2
g014602
3
g014609
g01461 1