Setup - Toro 41086 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Grommet,large
Carriage bolt (5/16 x 3/4 inch)
Lock nut (5/16 inch)
Computer console assembly
Hand Knob
Pivot bracket (2009 and older only)
Hose barb fitting, 90 degree
Hose, long
Hose clamp
Screw, flange head (1/4 x 3/4 inch)
Lock nut (1/4 inch)
Flowmeter
Gasket
Flowmeter barb fitting, straight
Hose clamp, worm screw
Hose, short
Boom valve caps
Plug
O-ring, large
Grommet,large
Mounting bracket (2010 and newer only)
Carriage bolt (5/16 x 3/4 inch)
Lock nut (5/16 inch)
Computer console assembly
Hand Knob
Pivot bracket (2010 and newer only)
Hose barb fitting, 90 degree
Hose (49in length)
Hose clamp
Screw, flange head (1/4 x 3/4 inch)
Lock nut (1/4 inch)
Flowmeter
Gasket
Flowmeter barb fitting, straight
Hose clamp, worm screw
Hose, (53in length)
Boom valve caps
Plug
O-ring, large
Note: Determine the left and right sides of the machine from the normal operating position.
Note: Duplications in the parts list is to distinguish needed parts for the different installation procedures as they
pertain to changes in the machine from model year to model year. Use the parts list for the model year of the
machine targeted for installation. Surplus parts may remain.
Qty.
1
2
2
1
2
1
1
1
5
2 Install the ProControl (for model year 2009 and older only).
2
1
2
2
2
1
3
1
1
1
1
4
4
1
2
1
1
1
5
Install the ProControl (for model year 2010 and newer
only).
2
2
1
2
2
2
1
3
1
1
4
Use