Initially Field-Testing The System - Toro 41086 Operator's Manual

Note: The pump should increase the pressure until
it reaches the desired rate if a Self Test speed has
been entered.
13. Turn the Master Boom Control (foot) switch to the
Off position.
Note: The system stops the pump.
14. Turn the Agitation switch to the On position.
Note: The system starts the pump and increases
the pump speed until the pump reaches the preset
agitation pressure. The system goes to this pressure
when the booms are off and the pump and agitation
are on.
15. Turn the Agitation switch, and the Pump switch
to the Off position.
Initially Field-testing the
System
Before operating the spray system, perform this
procedure.
1. Drive the vehicle at the desired spraying speed with
the sprayer booms off.
2. Press the [Speed] key to verify the speed readout.
3. Turn the Spray pump control switch to Rate 1.
4. Turn the Power switch to the On position.
5. Turn the Foot switch to the On position.
Note: Use the Foot switch when all the booms
are to be turned on.
6. Ensure that the Boom 1, Boom 2, and Boom 3
switches are in the On position.
7. Set the Man/Rate switch to Rate 1.
8. Increase or decrease the vehicle speed by 1 mph
(2 km/h).
Note: The system should automatically correct
the target application rate. If the system is not
correcting the application rate, review the Initial
System Setup; then refer to Troubleshooting.
9. After spraying a swath, switch the foot switch to the
Off position to shut off the spray flow to all booms.
Note: This also shuts off the acreage totalizer.
10. Verify the area covered and the volume of material
sprayed.
16