Self-Testing The Console Computer; Activating The Data Lock; Changing The Data Lock - Toro 41086 Operator's Manual

Enter the time of day based on a 24-hour day. For
example, 1:30 p.m. is 13:30. You can also enter 0 to
measure elapsed time.
Note: This data is lost each time the power is turned
off.
To set the date, do the following:
1. Press the [Time] key.
The display shows MONTH.
2. Press the [Enter] key to change the month.
3. Press the [Time] key.
The display shows DAY.
4. Press the [Enter] key to change the day.
5. Press the [Time] key.
The display shows YEAR.
6. Press the [Enter] key to change the year.
7. Press the [Time] key.
The display shows POWER DOWN DAY.
Displaying Data
To display the following data, do the following:
Total Area
Press the [Total Area] key.
Total Volume
Press the [Total Volume] key.
Note: To change the total volume to 0, enter 0.
Field Area
Press the [Field Area] key.
Field Volume
Press the [Field Volume] key.
Note: To change the total volume to 0, enter 0.
Distance
Press the [Distance] key.
Note: The distance is displayed in meters. To change
the total volume to 0, enter 0.
Speed
Press the [Speed] key.
Vol/Min
Press the [Vol/Min] key.
Area/Hour
Press the [Area/Hr] key.
US, TI, TU, SP1, SP2, or SP3
Press and hold the [Self Test] key.Press the [Total Area]
key.
Note: These parameters will alternately appear on
the display.
Data Menu
You use this key when you attach additional devices
such as a data logger or a GPS. Refer to the operating
manuals for these devices for how to program them.
Note: Do not change the other values for the PWM
(pulse width modulation); they are preset for the system.
Self-Testing the Console
Computer
The self test allows you to simulate the speed for testing
the system when the vehicle is not moving.
1. Press the [Self Test] key.
2. Enter the speed in mph or km/h.
3. Press the [Enter] key.
4. Press the [Speed] key to verify the speed.
The speed shows in the display.
Note: The self test speed will clear itself when the
speed sensor detects that the vehicle is moving.

Activating the Data Lock

This is an optional feature that prohibits users from
entering data without first entering the data lock code.
1. Press [Data Menu] several times until you see
PRESS ENTER FOR DATA LOCK on the display.
2. Enter a 4-digit code and press the [Enter] key within
15 seconds.

Changing the Data Lock

1. Press the [Data Menu] key several times until you
see the PRESS ENTER FOR DATA LOCK in
the display.
2. Press the [Enter] key.
Note: The display shows OLD CODE E.
3. Enter a 4-digit code and press the [Enter] key within
15 seconds.
4. Press the [Enter] key.
14