Toro 41086 Operator's Manual page 8

1
5
4
1. Flowmeter assembly
2. Hose, shorter
3. Manifold, boom valve
8. Install the hose to the flowmeter. Lightly lubricate
the barb on the flowmeter with a non-petroleum
based lubricant, such as vegetable oil. The flow
direction arrow should be pointing away from the
installed hose. This way the flow direction arrow will
be pointing to the right side of the machine once
installed.
Important: Installing the flowmeter with the
arrow pointed in the wrong direction can result
in damage to the flowmeter.
9. Slide the hose clamp into position over the flowmeter
barb and tighten to secure.
10. Locate the remaining hose in loose parts. Lightly
lubricate the existing barb on the right side of the
boom valve manifold with a non-petroleum based
lubricant, such as vegetable oil. Install the hose
onto the boom valve inlet barb fitting completely
(Figure 9).
11. Slide two hose clamps onto the hose and route open
end of the hose around the right upright of the
boom mounting frame up to the installed flowmeter
bracket.
Important: Hoses may need to be trimmed to
avoid kinks.
12. Lightly lubricate the open barb on the flowmeter with
a non-petroleum based lubricant, such as vegetable
oil. Install the open end of the routed shorter hose
onto the outlet barb fitting of the flowmeter.
2
3
G013318
Figure 9
4. Hose, longer
5. Flowmeter mounting
bracket
13. Secure the shorter hose to the manifold and
flowmeter respectively by sliding the hose clamps
into positions over the barb and tightening.
14. Secure the flowmeter assembly to the flowmeter
bracket with hose clamps.
15. Locate the spray system wiring harness routed to
the boom valve manifold. Locate the capped round
connector labeled flowmeter.
16. Remove the cap to expose the three-pin plug and
connect it to the wire coming from the flowmeter.
Secure the locking rings any locking rings if available.
Inspect all work to ensure all hose clamps are tightened.
Removing the Boom Bypass Assembly
This system is designed to work with a diaphragm pump
and operates without the boom bypass assembly.
Important: Before operating the spray system with
the console computer, the boom bypass manifold
must be removed.
1. Remove the nut securing the bypass hose fitting
to the boom manifold. Under the main tank,
disconnect the other end of the hose assembly from
the main tank. Retain all fasteners.
Note: Retain all parts from this hose assembly so
the Electric Hose Reel Kit or Spray Gun Kit can be
properly installed at a later time.
2. Remove all three forks holding the bypass manifold
onto the boom valves (Figure 10). Retain all
fasteners. Remove the bypass manifold.
4
3
1. Boom valves
2. Forks holding bypass
manifold, remove
8
1
2
G013322
Figure 10
3. Manifold, boom bypass
4. Bypass manifold assembly
forks, do not remove