Toro 41086 Operator's Manual page 7

6. Plug the cables into their corresponding inputs on
the rear of the console computer and secure the
cables by rotating the locking rings.
7. Assemble the computer console to the pivot bracket
with two hand knobs (Figure 6).
8. Attach the console computer assembly to the
mounting bracket. Secure the pivoting bracket to
the mounted bracket as shown in Figure 6 using two
carriage bolts (5/16 x 3/4 inch) and two lock nuts
(5/16 inch). Finger tighten the fasteners at this time.
9. Swing the console assembly on the bottom mounting
bracket until it faces the desired position. Tighten
the fasteners installed previously.
10. Adjust the pivot angle of the console face to the
desired position and tighten the hand knobs on
either side console to secure the position.
Installing the Hoses and Flowmeter
1. Loosen the hose clamp securing the boom supply
hose to the right angle barb coming from the right
side of the boom valve manifold. (Figure 7). Remove
the hose from the barb.
1
8
7
6
5
G013317
1. Open plate between the
manifold and the main
tank.
2. Boom valves
3. Boom supply hose
4. Boom bypass hose
2. Move to the lower tee fitting below the boom valve
assembly (Figure 7). Remove the fork securing the
barb and hose to the right side of the tee fitting.
Retain the fork and one hose clamp.
2
Figure 7
5. Uprights, boom mounting
frame
6. Lower tee fitting
7. Manifold, boom valve
8. Manifold, boom bypass
3. Locate the 90 degree fitting and long hose in
loose parts. Lightly lubricate the barb with a
non-petroleum based lubricant, such as vegetable
oil. Install barbed fitting into the end of the 49 inch
long supply hose from loose parts. Slide the hose
clamp next to the fitting body and tighten to secure
the hose to the fitting.
Important: Do not use petroleum-based
lubricants such as grease or oil because they can
damage the hose and contaminate the system.
4. Install the fitted end of the new supply hose assembly
into the open end of the tee so that the barb and
hose point downward. Secure the assembly to the
tee with the fork removed previously.
5. Move the valve manifold assembly. Attach the
flowmeter bracket to the open plate between the
manifold and the main tank (Figure 7). Use two
flange head screws (1/4 x 3/4 inch) and two flange
nuts (1/4 inch) to secure the bracket to the plate.
6. Assemble the flowmeter:
1
3
1. Worm screw clamp
2. Barbed fittings
4
A. Assemble the gaskets and barbed fittings to the
flowmeter (Figure 8).
B. Secure the fittings to the flowmeter body using
two worm screw clamps
7. Route the open end of the new supply hose installed
previously behind the left boom frame upright, up
and back over the location of the installed flowmeter
bracket. Slide a hose clamp onto the open end of
the longer hose (Figure 9).
Important: Hoses may need to be trimmed to
avoid kinks.
7
1
2
3
4
3
2
Figure 8
3. Gasket
4. Flowmeter body
G013324