Product Overview; Controls - Toro 41086 Operator's Manual

3. Install three bypass caps onto the all boom valves
and secure them with the forks removed previously
(Figure 11).
4
3
Figure 11
1. Fork
2. Manifold, boom valve
4. From inside the tank, remove fork securing the
bypass hose barb to the bulkhead. Retain all
fasteners. Remove the bypass hose barb from the
bulkhead.
5. Lightly lubricate the O-ring with a non-petroleum
based lubricant, such as vegetable oil. Install the
O-ring onto the plug. and install the plug into the
bulkhead. Secure the plug with the fork removed
previously.
1
2
G013323
3. Bypass cap
4. Bypass caps and forks,
installed

Product Overview

1 4
6
1. Power switch
2. Flow control switch
3. Display
4. Calibration keys

Controls

The ProContro ™ System consists of a computer-based
control console, a speed sensor, and a turbine-type
flowmeter.
Become familiar with the controls (Figure 12) before
you start the engine and operate the sprayer.
Power switch
This switch turns the console power on and off. Turning
off the console computer does not affect the data stored
in the computer.
Flow control switch
This switch allows you to automatically or manually
control the spray system. There are 2 automatic
positions and 1 manual position.
Display
The display shows the function and calibration data.
Calibration keys
These keys allow the operator to enter data into the
console computer to calibrate the spray system.
Function keys
These keys display needed data, such as the total area
sprayed, the total volume of material sprayed, the vehicle
speed, and the volume of material remaining in the tank.
9
3
2
G013304
5
7
Figure 12
5. Function keys
6. CE key
7. Enter key