Data Format (Format) - Printek FP5000 series User Manual

The Menu

Data format (Format)

Baud Format
Back Next
1 2 3 4
8bit No 1Stop*
Set < > Exit
1 2 3 4
68
This parameter serves to define the number of data bits, the parity
check for received data bytes and the number of stop bits per data
byte.
Press Format (3) key.
Online
Setup
Use the < (2) or > (3) key to select the desired setting.
Setting Options: see table below
Online
Default Setting: 8 Bit No 1 Stop
Setup
1 number of data bits
1 Sets the number of data bits: You can select 7 or 8.
2 The parity test for received data bytes can be selected. NO cau-
ses transmission in both directions without parity bit. If EVEN or
ODD is selected, the bytes are checked if they have even or odd
parity. The selection of MARK or SPACE causes a data byte
transmission with parity bit, but without checking the received da-
ta. Transmission data with parity bit is always marked with 1
(MARK) or 0 (SPACE).
3 Selects one or two stop bits per data byte.
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
2 parity test
7 Bit
7 Bit
7 Bit
7 Bit
7 Bit
7 Bit
7 Bit
7 Bit
7 Bit
8 Bit
8 Bit
8 Bit
8 Bit
8 Bit
8 Bit
3 number of stop bits
No
Even
Odd
Even
Odd
Mark
Spc
Mark
Spc
No
No
Even
Odd
Mark
Spc
User guide
2 Stop
1 Stop
1 Stop
2 Stop
2 Stop
1 Stop
1 Stop
2 Stop
2 Stop
1 Stop
2 Stop
1 Stop
1 Stop
1 Stop
1 Stop