Setting The Tear Position - Printek FP5000 series User Manual

Settings
Setting the tear
position
Adjust Paperway
Form Char
1 2 3 4
TOF
Head Tear
1 2 3 4
TearAdj= 00/72"*
Set < > Exit
1 2 3 4
46
If the tear position of the paper is not aligned with the tear edge of
the printer, you can adjust it. Inserted paper needs to be torn off if
necessary and retracted to park position.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Online
Setup
Press the Tear (4) key.
Online
Setup
Press the < (2) or > (3) key to move the perforation to the desired
position. Confirm the input by pressing the Set (1) key. Confirm the
Online
input again by pressing the Setup key. The printer is reset to the ini-
tial status.
Setup
The correction made – a maximum of approx. 1" (2.5 cm) in
each direction – will be retained after switching the printer off.
It can be set separately for each paper path.
Make sure that the set form length corresponds to the actual
length of the forms you are using.
User guide