Skiping Perforation (Skip); Selecting Start Signal For Escape Sequence (Escchar) - Printek FP5000 series User Manual

User guide

Skiping perforation (Skip)

LPI Skip
Back Next
1 2 3 4
Skip= 0.0 Inch *
Set < > Exit
1 2 3 4
Selecting start signal for
escape sequence
(ESCChar)
ESCChar Emulate
Back Next
1 2 3 4
ESCChar=ESC
Set < > Exit
1 2 3 4
Skips the perforation; 7 different values (in inches) can be defined.
Press Skip (3) key.
Online
Setup
Use the < (2) or > (3) key to select the desired setting.
Setting Options: 0.0 to 3.5 Inch in steps of 0.5 inch
Online
Default Setting: 0.0 Inch
Setup
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Selects the start signal for control sequences. Setting ESC: Only
character Escape can be used. Setting ESC+$$: Character Escape
or alternatively two $ characters ($$) can be used. For more infor-
mation see the section
Press ESCChar (2) key.
Online
Setup
Use the < (2) or > (3) key to select the desired setting.
*
Setting Options: ESC/ESC+$$
Online
Default Setting: ESC
Setup
Confirm the setting by pressing the Set key (1).
The $$ procedure (page
The Menu
146).
65