Connecting The Power Cord - Onkyo C-705TX Instruction Manual

Connecting to the other components
Connecting the
If you are using other ONKYO components equipped
with connectors, you can control these com-
ponents using the amplifier's remote controller.
Before connecting
• The amplifier must be connected in the
system hookups for
• Each component has two
is no difference between those connectors.
• The components may be connected in any order.
• Remote control operation is not possible if only
the remote control cable is connected to
the connectors. Connect the audio connec-
tion cables correctly.
The illustration below is the
With these hookups, you can operate the CD Syn-
chro Recording (see "CD/MD synchro recording"
on page 8).
Tuner
Amplifier
Cassette Tape Deck
C-705TX
Note
An remote control cable equipped with a 1/
8 in. (3.5mm) diameter miniature two-conductor
phone plug is included with this unit and with ev-
ery tuner and cassette deck that bears the
mark.
12
connector
control operations.
connectors. There
hookup example.
cable
cable
Supplied
cable
REMOTE
CONTROL

Connecting the power cord

Insert the AC power cord into a wall
outlet. The STANDBY indicator lights.
STANDBY/ ON
STANDBY
Light
• To use the unit with the other Onkyo Sepa-
rate Collection series components, follow the
connection diagram in the A-905TX/R-805TX
instruction manual to connect the unit to the
system.
• If you press the (OPEN/CLOSE) button while
the unit is in the STANDBY mode, the power
will turn on and the display will light up auto-
matically.
To wall outlet