Adjusting The Cutting Unit; Installing The Grass Basket - Toro 04036 Operator's Manual

1. Locking clip
7. Rotate wheel back and forth until it slides completely
onto axle and locking clip is secured in groove on
axle shaft.
8. Repeat procedure on opposite side of machine.
9. Inflate the tires to 12 to 15 psi. (574 to 718 Pa).
5

Adjusting the Cutting Unit

No Parts Required
Procedure
Before operating the machine, complete the following
adjustments:
• Level the rear drum to the reel.
• Adjust the bedknife to the reel.
• Adjust the height-of-cut.
• Adjust the grass shield height
• Adjust the cut off bar.
Refer to the Cutting Unit Maintenance section in
Maintenance for instructions on performing these
procedures.
Figure 8
6

Installing the Grass Basket

Parts needed for this procedure:
1 Grass basket
Procedure
Grasp basket by top lip and slide it onto the basket
mounting rods (Figure 9).
1. Grass basket
13
Figure 9
2. Basket mounting rod