Specifications; Attachments/Accessories - Toro 04036 Operator's Manual

Choke Lever
The choke lever (Figure 13) is located on left front of
the engine. The lever has two positions: Run and Choke.
Move the lever to the Choke position when starting
a cold engine. After engine starts move lever to Run
position.
Figure 13
1. Choke lever
Fuel Shut-Off Valve
The fuel shut off valve (Figure 13) is located on left
front of engine. The valve has two positions: Closed
and Open. Move the lever to the closed position when
storing or transporting machine. Open the valve before
starting the engine.
Recoil Starter
Pull recoil starter handle (Figure 14) to start engine.
Figure 14
1. Recoil starter
Kickstand
The kickstand (Figure 14) is mounted to the rear of
machine and is used to raise the rear of machine for
installation or removal of the transport wheels.
2. Fuel shut off valve
2. Kick stand

Specifications

Model 04036
Width
36 inches (91 cm)
Height 47 inches (119 cm)
Length with basket 59 inches (150 cm)
Dry weight (with 208 lb (94 kg.)
basket and Wiehle
roller; without
wheels or grooming
reel)
Width of cut 21 inches (53 cm)
Height of cut 1/8 to 1-1/4 inches
(0.3 to 3.2 cm)
Clip 0.15 inch (3.7 mm)
Engine speed Low idle – 1600
±100, High idle –
3600 ±100

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
15
Model 04037
41 inches (104 cm)
41-1/2 inches
(105.4 cm)
54-1/4 inches
(137.8 cm)
229 lb (104 kg)
26 inches (66 cm)
1/8 to 1-1/4 inches
(0.3 to 3.2 cm)
0.15 inch (3.7 mm)
Low idle – 1600
±100, High idle –
3600 ±100