Product Overview; Controls - Toro 04036 Operator's Manual

Product Overview

Controls

Figure 10
1. Traction drive lever
2. Throttle control
3. On/off switch
Traction Drive Lever
The traction drive lever (Figure 10) is located on the
front right side of the control panel. It has two positions:
Neutral and Forward. Pushing the lever forward engages
the traction drive.
Throttle Control
The throttle control (Figure 10) is located on top right
side of the control panel. The lever connects to and
operates throttle linkage to the carburetor. The engine
speed can be varied from 1600 to 3600 RPM.
On/Off Switch
The on/off switch (Figure 10) is located on the top of
the control panel. Move switch to the On position to
start the engine and the Off position to stop the engine.
Service Brake
The service brake (Figure 10) is located on top left side
of control panel. You can use the brake to slow or stop
the machine.
Parking Brake
The parking brake (Figure 10 & Figure 11) is located at
the base of the service brake. Fully engage the service
brake, push in the parking brake knob and allow the
service brake to rest on the parking brake pin. Engage
4. Service brake
5. Parking brake
the service brake to release the parking brake. You must
release the brake before traction drive is engaged.
Reel Drive Lever
The reel drive lever (Figure 12) is located on the
right front corner of the machine. The lever has two
positions: Engage and Disengage. Pull up on the lever
to engage the reel or push it down to disengage the reel.
1. Reel drive lever
14
Figure 11
Figure 12