Table of Contents
Advertisement
1. Large bolt
2. Washer
3. Spring
4. Small bolt
6. Place a nut runner over the end of the spring pointing
towards the rear and move the end of the spring over
and under the kickstand spacer (Figure 6).
1. Nut runner
2. Spring
Figure 5
5. Small spacer
6. Left handle end
7. Large spacer
8. Locknut
Figure 6
3. Move the spring end under
the kickstand spacer
4. Spring end under frame
4
Installing the Transport
Wheels
Parts needed for this procedure:
1
Wheel shaft, right
1
Wheel shaft, left
2
Transport wheels (obtain separately)
Procedure
1. Push the kick stand down with your foot and pull
up on the handle to support the mower on the kick
stand.
2. Apply #242 Loctite to the threads of the wheel
shafts.
3. Thread the right wheel shaft into the drive pulley on
the right side of the machine (Figure 7).
Note: The right wheel shaft has left hand threads.
1. Right wheel shaft
4. Torque the shaft to 65 to 75 ft-lb (88 to 101 N-m).
5. Slide the wheel onto the axle (Figure 8).
6. Pivot the wheel locking clip away from center of
the wheel allowing it to slide farther onto the axle
(Figure 8).
12
Figure 7
Advertisement
Table of Contents
