Installing The Hairpin Cotter Pins; And Spacers; The Safety Video - Toro 30317 Operator's Manual

Figure 11
1. Control rod
2. Fixed control bar
3. Parking brake lever
7. Check the parking brake adjustment. Refer to
Checking the Brakes in theBrake Maintenance,
page 37.
Step
5
Installing the Hairpin Cotter
Pins and Spacers
Parts needed for this step:
2 Hairpin cotter pin
6 Spacers
Procedure
Unused height-of-cut spacers may be stored on
posts and retained by a hairpin cotter.
Note: Make sure there is at least one spacer used
on each height-of-cut post.
1. Remove the existing rear hairpin cotter pins
from the rear height-of-cut posts (Figure 12).
2. Install a spacer onto both rear height-of-cut
posts and install the hairpin cotter pins
(Figure 12).
4. Upper control bar
5. 1 to 1-1/4 inch (25-32mm)
gap
6. Fitting
Figure 12
1. Hairpin cotter
2. Spacer
3. Install a spacer onto both front height-of-cut
posts and install the hairpin cotter pins.
4. On the opposite side of the muffler,
install unused spacers onto front and rear
height-of-cut pins and insert the hairpin cotter
pins (Figure 13).
Figure 13
1. Hairpin cotter
2. Unused spacers
16
3. Height-of-cut post (rear
shown)
3. Height-of-cut post (front
shown)